December 23, 2024

Standard installation and use of safety belts

The seat belt includes two shoulder straps and one waist belt. The fixed point of the seat belt is two belts, two shoulder belts or one behind the backrest of the seat, and one symmetrical to the center line of the backrest. The seat belt used must meet the technical standards of the FIA ​​8854/98 or 8853/98. The seat belt must be fitted with a snap release system or a twist release system.
installation

You can use the original seat belt anchorage on your car.

The equivalent position of the seat belt fixing point.

The angle between the shoulder strap towards the back of the seat and the horizontal line of the seat shoulder shall not be greater than 45 degrees, and the maximum angle with the center line of the seat shall be 20 degrees (dispersion or convergence). Make use of the manufacturer's original fixed point as much as possible.

Seat belts should not be installed in seats without a headrest or in seats with non-adjustable headrests (with no gaps between the backrest of the seat and the headrest). If the shoulder straps are cross-fixed behind the seat, the shoulder straps must pass from both sides of the headrest pillars. Conversely, if the shoulder strap does not form a cross behind the seat, the shoulder strap must pass between the two pillars of the head restraint.

If bucket seats are used, the waist belts or crotch seat belts should pass through the hole in the lower part of the seat and should not be used outside the edge of the seat to maximize the rider's pelvis. It must be noted that the waist or crotch seat belts will not be damaged by friction when passing through the seat with holes.

If it is not possible to install a shoulder belt at the original fixing point, the belt can be mounted on an additional lateral support bar and secured by a winding method or bolts. If bolted, the insert part of the bolt body must be welded to the fixing point.

Where there is a new installation point on the car body, a reinforcement plate must be used at this installation point. Its area is at least 40 cm2 and its thickness is at least 3 mm.

Use of safety belts

It is not allowed to change the working structure of the seat belt.

In the event of a serious collision or rollover incident, the safety belt must be replaced.

If the seat belt is broken, bulged or loosely deformed due to chemical action or sunlight, the seat belt must be replaced.

If the seatbelt metal connection member is bent, deformed or rusted, the seatbelt must be replaced.

When the use of the seat belt is not good, the seat belt must be replaced.

If a non-IFA registered seat belt is used, its thickness is not less than 1.5 mm and the width is not less than 50 mm.



Inflatable Arch Sprinkler

The inflatable arch sprinkler, children can pass through the curtains, play in the backyard, courtyard and lawn, bringing a lot of summer fun in the hot weather. The inflatable sprinkler is made of high -quality thick PVC materials, which is durable to prevent holes or puncture.

The Inflatable Sprinkler Items is easy to use. It needs to be inflated with a gas pump to the sprinkler (excluding), connect it to any garden hose, and then fill the base with water to help it stand stably. Dowry smoothly in the holes. By the way, if it is flipped or over, the water in the base must be full.

The inflatable sprinkler is not only suitable for summer outdoor sprayed toys for children, boys and girls, but also very suitable for children's swimming pools, beach lawn and children's birthday party. Any interesting parents can run with their children under the sprinkler, for a few hours, bringing a lot of fun in hot summer weather.

arch sprinkler, inflatable sprinkler arch, arch sprinkler toys, arch water sprinkler, inflatable water arch sprinkler

Lixin Outdoor Product Co., Ltd , https://www.jmInflatableboat.com