Our factory recommended granular activated carbon adsorption of mercury-containing industrial waste water purification operations of the following two. 1. Granular activated carbon column filtration method The test uses strip activated carbon, beacon charcoal and self-made activated charcoal produced by activated carbon plant, and is crushed and sieved to make 2.262～1.397mm (8～12 mesh). Sample 1 is industrial wastewater containing 0.94 to 2.8 mg of mercury, and the other is simulated industrial wastewater containing 1 to 6 mg of mercury. The carbon particles are packed in columns, and the waste liquid passes through the single-tube, double-tube and three-tube series activated carbon columns at a rate of 1 m∕h, and the adsorption rate of mercury is above 98% on average. The mercury-absorbing charcoal is returned to the use after distilling mercury, but the mercury absorption rate is slightly reduced (over 96%) when used again. Second, activated carbon powder adsorption method The mercury-containing wastewater treatment tank established according to the small test results is divided into three layers. The lower layer of the pool is below the surface of the earth and functions as catchment and sedimentation. After the wastewater is filled with the lower pool, the pump automatically draws the water into the upper tank to which the activated carbon powder is added. After the water is full, the compressed air tube at the bottom of the pool is automatically compressed and stirred for half an hour. After the sedimentation sample test, the supernatant is discharged after the mercury content meets the discharge standard; if it is not required, it is placed in the middle pool for repeated treatment. The secondary treated wastewater is discharged by a water pump through a microporous plastic filter tube. The wastewater purified by this method has clear water and no carbon powder. The treatment operation is intermittent, and each batch of mercury-containing wastewater is treated for 40 tons, and the process takes about 2 to 3 hours. When the treated wastewater contains 1 mg/L of mercury, 50 g of waste activated carbon powder is added per liter of the pharmaceutical plant. After treatment, the mercury content of the wastewater decreased to 0.0215 mg∕L, and the mercury removal rate was over 97%. The mercury-carrying carbon powder is recovered by distillation.
Lead Stabilizer for PVC Foaming Board
CM-107 is a solid composite stabilized by a variety of functional lead stabilizers and high-efficiency adjuvants. The stabilizer has good internal and external lubrication balance, widely processing and excellent thermal stability. CM-107 is superior to single lead stabilizer because of its excellent dispersibility and light stability in PVC resin. In addition, it has good weather resistance, promotes plasticization, makes the PVC products thickness is uniform, get good surface and can also improve the impact resistance. Furthermore, it is meet environmental health standards, no dust, easy to use, and reduce labor intensity.
Pvc Foaming Board,Foam Sheets,Foaming Board,Pvc Foamex HENGSHUI HOMART TECHNOLOGY CO.,LTD , https://www.hsjzgroup.com