Gantry Hydraulic Machine For Pressing And Installing Gantry Hydraulic Press,Gantry Hydraulic Machine,Press Mounting Of Rotor And Stator,Hydraulic Machine For Pressing And Installing Wuxi DALI Hydraulic Machinery Factory , https://www.hydraumatic.com
2. Check whether the tool compensation number is correct before driving. Perforated tape Take care to remove dust.
3, the relative position of each handle should meet the requirements of the knife map.
4. Tools or other items must not be placed near the button tray or reader.
5. The circuits of each department must have good insulation, and the relays controlling the clamping device should be checked frequently to prevent the workpiece from being thrown out.
6, the original organic bed additional numerical control device, should remove the original handle or add insurance spring, to avoid the program control and manual coexistence, the moving parts suddenly turn hurt.
7. Open the strong box, turn on the regulator power supply, and check if the supply voltage is normal.
8. Start the oil pump and empty the tape 2 or 3 times to observe whether the displayed figures meet the requirements of the program.
9. Press the pre-clear and pre-clear button, and then start the drive box.
10, check the hydraulic chuck, workpiece installation is reliable.
11, there is a manual position of the origin, put the dial indicator after work.
12. After the work, turn off the drive of the numerical control box and the power supply, and finally close the drive box and the strong power supply.
CNC machine tool safety operation specification
1. Observe the general safety operation procedures of the machine tool worker and wear labor protection articles as required.