December 22, 2024

Autumn and winter car care

Autumn and winter car care

1. Seasonal changes The car should pay attention to checking the seasonal changes. The car should do a careful inspection to check the parts to eliminate hidden dangers. The seasonal changes will have a certain impact on the car components, especially the thermal expansion and contraction and rain erosion, it is easy to cause parts deformation, aging . The timely inspection of the interior parts of the vehicle can eliminate the hidden dangers.

2. Winter and winter car maintenance common sense Winter should first start the ignition vehicle, wait until the engine works properly, and then turn on the headlights and other electrical equipment; parking should be closed before the electrical appliances, and then turn off; parking as much as possible not to consume large amounts of electricity, especially electric Windows, headlights, stereos and other power-hungry devices.

Winter rain, snow, roads after the snow, salt water, car chassis is always directly deal with the rain, snow, it is easy to rust. Speeding tires throw snow with high salinity onto the chassis of the car, making the chassis of the car susceptible to rust. Therefore, before the winter, you should give the chassis a rust-proof care. When you are in the snow, you are not afraid of damaging the chassis.

Winter disease is mainly due to cold start failure, battery loss and heating system failure. Cold start failure is mainly manifested in the vehicle must be repeated many times to start, or even unable to start. The battery capacity in the low temperature environment is much lower than that in the normal temperature. A battery that is normally used in a warm place will suddenly lose its electricity when it is cold. With the winter cold start, the power consumption is particularly large. Therefore, the use of the battery for about two years is prone to the disease.

3. Other things to pay attention to First, the battery. Always check the electrolyte level and specific gravity so that the battery always maintains a good condition.

Second, the dry filter cleaning. As we all know, in most parts of China, windy and windy in winter, the small sand particles in the wind form an abrasive on the wall of the cylinder after the air enters the cylinder, which accelerates the wear of the cylinder and sticks with the oil on the led screen. Accelerate the deterioration of the oil, so every 5,000 kilometers must be cleaned air filter dust.

Third, the engine. Pay attention to checking whether the temperature of the engine is normal. In fact, it is to check the opening of the thermostat. Whether the temperature of the engine is too high or too low, the wear of the engine will be exacerbated.

Fourth, tires. Pay attention to the tire pressure of the spare tire. Look at the plastic tire wall for cracks, breaks, or bulging packets. If you have any of the above conditions, you must go to a professional service station immediately.

Fifth, the wipers. If it is damaged, you must replace it and fill the windshield cleaner inside the hood to maintain good visibility and visibility.

Sixth, remove the frozen ice from the glass. The car parked outside the garage will form a layer of frozen thick ice on the glass after a cold night. Do not use thermal hydrolysis if you are anxious to go to school or work. This will not only make the window glass crack, the wiper deformation, but also cold and cold, hot water poured out, and immediately frozen, but increased difficulty. The method recommended to you is: Open the air conditioner to hot air, the wind blow mode is the front windshield, until the wiper is naturalized. At the same time, slowly scrape the ice cubes from the ice joints with scraping snow and ice. If you do not have a snow shovel brush, you can use a credit card to slowly scrape.

CNC Lathe With Linear Guideway Flat Bed

Cnc Wood Lathe,Flatbed Cnc Lathe,Cnc Automatic Lathe,Linear Guideway Cnc Lathe

Ningbo junfa CNC Equipment Co. Ltd. , https://www.intimecnc.com