[Weifu Sunshine] [Wuxi Professional Sun Room] window rubber seal off how to do!

The reason for this situation:
1. When the glass is installed, the debris in the notch is not removed in time, so that the glass and the notch are not aligned.

2. The gap between the glass and the glass notch is uneven, the rubber strip is in poor contact with the glass and the glass groove, and the glass notch protrudes. The seal can be easily pulled off by hand.

3. The rubber strip is not disconnected at the corners and is not glued.

The measures for rectification are:

1.Before installing the glass, carefully remove the debris in the slot, such as mortar, brick, wooden block, etc., place the glass carefully when it is placed, ensure that the gap on both sides is even, and fix it in time to prevent collision displacement. Notch center.

2. The rubber seal cannot be pulled too tightly, and the length of the blanking is 2O-3Omm longer than the assembly length. The installation should be in place, the surface straight, and glass, glass notch close contact, so that the glass around the force. The rubber strips should be cut off at the corners and glued firmly at the disconnection.

3. When sealing the glass with sealant, the glass should be squeezed with a rubber strip or a rubber block to leave gaps in the plastic injection. The depth of the plastic injection should not be less than 5mm. Before the adhesive is cured, the glass should be kept free from vibration.

Wuxi Weifu Sunshine Window Industry declared