The tear-off cap for oral liquids is divided into two types, i.e.: topâ€pull type and sideâ€pull type.
Involving in multiple working procedures, such as the: punch forming of aluminum cap, injection molding of plastic cap, press / cutting indentation, surface treatment, cleaning, riveting, inspection, inner and outer packing. The size and color could be satisfied on the request of user.
Tear-Off Cap For Oral Liquids,Tear Off Cap,Aluminium Tear Off Cap,Glass Bottle Of Tear-Off Cap YANGZHONG HONGYUN BOTTLE CAPS MAKING FACTORY , https://www.hongyunyz.com
Use and maintenance of thermostatic shaking incubator
Use and maintenance of thermostatic shaking incubator
In the daily use operation of the constant temperature shaking incubator, we should pay attention to the following precautions:
1. Read all instruction manuals.
2. User-supplied electrical outlet rating parameters should not be less than the machine's electrical rating and have good grounding measures.
3. When replacing the thermostatic shaking incubator fuse, pull the plug out of the socket.
4. After a fault in the wire or electrical equipment, it should be repaired by a professional. Use of accessories not recommended by the manufacturer can cause certain quality problems.
5. Use a thermostatic shaking incubator in a child-friendly environment. Care should be taken.
6. When using a constant temperature shaking incubator, it is forbidden to insert your fingers into the gap between the up and down movements.
7. The entire machine is strictly prohibited to use in direct sunlight.
8. When the constant temperature shaking incubator is used for cooling, the ambient temperature should be lower than 32°C, and when the ambient temperature is above 25°C, the opening times should be reduced as much as possible.
9. The heated object should be cooled at ambient temperature and then placed in the machine. It is forbidden to put the heated object directly into the refrigeration incubator to prevent danger.
10. When scrubbing the machine, unplug it first.
11. The use of medium speed within the speed range extends the life of the instrument.
12. When placing items on the workbench, proper intervals should be maintained between the test bottles to facilitate circulation of cold and hot air convection.
13. The use of medium speed within the speed range extends the life of the instrument.
14. The instrument should be placed on a firm bench and the environment should be clean and well ventilated.
15. Correctly use and pay attention to the maintenance of the instrument to keep it in good working condition and prolong the service life of the instrument.
16. During the continuous operation of the instrument, regular inspections shall be performed every three months; check the fuses, control components and fastening screws, and if any water droplets, dirt, etc., shall fall on the motor and control elements.
17. The bearing of the transmission part has been filled with a proper amount of grease (No. 1 Calcium-Naki) before leaving the factory. During continuous operation, the grease should be filled once every six months. The filling volume accounts for about 1/3 of the bearing space. .
18. Instruments are used regularly and natural wear is normal. After one year of use of the instrument, if abnormal noises are found in the motor and compressor, the bearings of the transmission part are worn out, the belt is loose or cracked, and the electronic control element fails, the company will continue to provide quality services and be assisted.
19. The constant temperature shaking incubator compressor should avoid continuous start.
20. When placing items on the workbench, proper intervals should be maintained between the test bottles to facilitate circulation of cold and hot air convection.