List of equipment required for 500 tons/day iron ore plant Device name Specification model Quantity (station) Power (kW) Remarks Trough feeder 980×1240 1 7.5 Jaw Crusher PE400×600 1 30 Cast steel frame Jaw crusher PEX250×1000 2 37 Cast steel frame Pendulum feeder 600×600 1 2.2 Straight ball mill GM2.1×4.0 1 245 Sorghum classifier FLG-2000 1 18.5 Extended type with sand scraper Magnetic separator CTB900×1800 1 4 Magnetic induction 2500 Gauss Magnetic separator CTB750×1800 2 3 Magnetic induction strength 1400 ~ 1800 Gauss Welded Bed Plate For Flanges Of Ship Pipe The flange welded single-sided seat plate is mainly installed on the top, side wall and bottom of the cabin or cabinet as the entrance and exit of the cabin or cabinet. Valves, accessories or pipes can be installed directly on the single-sided seat plate.
Flange welded single-sided seat plate is suitable for seawater, fresh water, oil, air and steam pipelines below 300 °C. The commonly used nominal diameter is 15~150 mm, and the nominal pressure is lower than 1.6 MPa. The shape of the single-sided seat plate is similar to the corresponding lap-welded Steel Flange.
Flange welded double-sided seat plates are generally used when pipelines pass through decks and tanks, and the two sides of the seat plate are respectively connected to valves, accessories or pipes. Welded Bed Plate For Flanges Of Ship Pipe,Flanges Of Ship Pipe Welded Bed Plate,Welding Base Plate Flange Of Ship Pipe,Ship Pipe Welding Base Plate Flange Fuyuan Marine Accessories Co., Ltd , https://www.fymarineparts.com
Compared with the single-sided seat plate, the double-sided seat plate has an extra shoulder and double-sided mounting stud bolts. The outer diameter of the shoulder is 10~20 mm larger than that of the corresponding flange, and the thickness of the shoulder is 6~12 mm.
Its scope of application and other structural dimensions are basically the same as those of the single-sided seat plate.
The manufacturing and installation methods of the flange-welded double-sided seat plate are basically the same as the single-sided seat plate, but when the screw holes are drawn, the positions of the upper and lower screw holes of the seat plate must be staggered from each other and must not overlap; deck or bulkhead The diameter of the hole on the top is 2~3 mm larger than the diameter of the seat plate.