Tying a tire, leaking a tire or puncturing a tire can cause the car to break down on the road. Many times you will find that when you don't need something, it will appear frequently in your field of vision, and when you urgently need it At the time, it could not find it. When you tire on the road, when you tire, it's very difficult to go to the place where you can pump up or make up your tires. If you call for help, it will take time. If you happen to be on the highway, it will be even more troublesome. Or do it yourself, learn more about a skill, it is much faster than asking for help, and it is not difficult to change the spare tire. First of all, you have to find a safe place. When the tires are flat, the car can still be opened. Therefore, you have to drive the car to the side of the road. It is best not to change it on the road. This will avoid which "big headed green" drove to pick you up to repair the car on the road. Then, make sure you can find the jack, the wrench to remove the tire nut, and the spare wheel. Collect these together and start changing the spare tire. 1) Parking Pull up the parking brake and pull it tightly to prevent the car from moving back and forth. 2) Use a wrench to loosen the nuts of the flat tires one by one. Generally turning counterclockwise is to loosen the nuts. Just loose it and do not unscrew it. 3) Jack, first find the steel fulcrum next to the leaky tire, do not top in the lower edge of the door, this fulcrum generally from the outer edge of about 10 cm, to determine the steel frame can be put below the jack. 4) Raise the jack. When raising the jack, the jack should stand upright. Do not tilt, or lower it once again. 5) After the leaky tire is vacant, stop raising the jack and then use a wrench to unscrew the loosened nut one by one. 6) Hold the flat tire with both hands and remove the tire. If you can't move it out, you can use your feet to jump over the outer edge of the tire and the entire wheel will loosen and then take it off. 7) Hold the spare tire and put it on the hub. Note that when installing the wheel, the nut hole of the wheel should be aligned with the nut hole on the wheel. This will take a little time and be patient. 8) Then tighten the tire nuts by hand, and then use the tire wrench to screw the nuts one by one, without using a great deal of effort, as long as it is screwed to the end. 9) After all the nuts are screwed to the end, the progenitor slows down the jacks and allows the spare tire to dry. 10) Don't forget to tighten the nut again with a tire wrench. If your strength is not great, then use your strength to tighten it. If you are wide-open, it will be enough to use your 80% strength. China Direct Thermal Jumbo Label,Thermal Label Jumbo Roll supplier & manufacturer, offer low price, high quality Direct Thermal Jumbo Label Stock,Label Material Jumbo Roll, etc. Direct Thermal Jumbo Label,Thermal Label Jumbo Roll,Direct Thermal Jumbo Label Stock,Label Material Jumbo Roll Jiangmen Hengyuan Label Technology Co., Ltd , https://www.jmhypaper.com