Structural Electromagnetic Wave Absorbing Materials Structural Absorbing Material Honeycomb,Microwave Absorbing Honeycomb Structure,Radar Absorbing Honeycombs Zhejiang Yuanbang Material Technology Co., LTD , https://www.yoboemiemc.com
So, how should the electronics factory maintain such equipment during the use of metal security doors? Today, the peacekeeping era technology to answer this question for everyone:
Since electronic factories use metal detection doors for a long time, they will all be turned on during working hours. This is a big job for equipment. How do you maintain it? 
1, after work at night, strive to close the security door, because the security door is an electronic product, long-term power at night, first, the aging rate increases, after all, any parts in the power state, will slowly aging, too long, naturally reduced performance.
2. It is not safe to power at night! Although there are security controls inside the security door to enhance the internal chip security control to prevent damage to the chip because of excessive current, but if you encounter thunder and lightning weather, high-voltage power may burn the motherboard chip may, this way, you need Changing the chip brought unnecessary losses and troubles.
3. Keep the surrounding environment of metal security doors dry and have less dust. The security inspection equipment uses a wooden material as a frame, because the wooden material does not bring about metal detection interference, and the light weight is suitable for use. However, this kind of material is not easy to use in a humid environment for a long time. In addition, where there is too much dust, it can easily enter the interior through the ventilation holes of the main chassis, rapidly aging the internal chip of the main chassis and causing malfunction.
The above three points are the precautions in the process of using the security door in the electronic factory. It is possible to properly maintain the equipment. An excellent quality equipment can be used for many years!
Electronic factory security door how to maintain?
Today, many electronic factories have purchased security gates to conduct electronic component safety inspections. Essentially, they are mainly used for theft prevention. After all, they are valuable for some precious parts, not all employees can do it. Abiding law, this is a practical problem!