SF-200 is a Hand belt type resistance forming machine which is the best selection for mass production.Easy adjustment,operation and long life.
SF-201 is the same as SF-200,Beside above ,they are Loose Tape resistance Former suitable for vertical or horizontal shaping of resistors and diodes.
SF-202Component bending forming machine is bulk, with resistance and diodes are available.Foot cutting, bending can be strengthened, foot long span can be adjusted.
SF-208FB Axial automatic resistor machine has three Models for Processing Different Type of Packing.
SF-206 The bulk Resistor Former has three models each for both M&C types.The difference are listed as follows:â‘ SF-206-MA;SF-206-CA for loose packed components â‘¡SF-206-MA;SF-206-CB for taped packed components â‘¢SF-206-MA;SF-206-C for using on both taped and loose packed components.
SF-208 Equipment K Type Resistance Molding Machine has three Models for Processing Different Type of Packing.â‘ Loose packed Model(SF-208-FA).â‘¡Taped Model(SF-208-FB).â‘¢ Loose packed/taped combinative Mode(SF-208-F).
SF-206MB The axial lead former m type has three models each for both M&C types.The difference are listed as follows:â‘ SF-206-MA;SF-206-CA for loose packed components â‘¡SF-206-MA;SF-206-CB for taped packed components â‘¢SF-206-MA;SF-206-C for using on both taped and loose packed components.It is also means automatic resistor forming m machine.
Resistance Molding Bending Machine,F Resistor Cutting Machine,Component Cutting Forming Machine,Components Lead Cutting Machines SINGSUN ELECTRONIC SCIENCE & TECH CO.,LTD , https://www.singsunautomatics.com
The machine adopts a 37kW AC motor, which drives the flywheel to rotate through the pneumatic clutch, and transmits it to the punching arm through the reducer. At the same time, the reducer synchronously drives the mold part to perform indexing rotation to realize stamping and die-out movement. The discharge specifications are 型90, 芰115, 芰135 and other types of briquettes. After the mold is rotated 60 degrees, the auxiliary punch is used to remove the material, and the belt is transported and manually packed. The driving device of the machine is matched with the pneumatic clutch and the safety clutch, which greatly improves the service life of the device, and is simple in operation and stable in operation.
Successful trial production of CX200 stamping machine
The CX200 stamping and Forming Machine, a new type of coal mining equipment, was successfully trial-produced at Shandong Laiwu Machinery Factory.