Because the feed carrier trucks are loaded with different types of feed and they have to experience different environments during transportation, after a long time, the rust outside the vehicle body will gradually increase. The following methods can be used to effectively reduce the body rust, which in turn can increase the useful life of bulk feed carriers. 1. Summer rainfall is high. Bulk feed carriers often work in the rain. After a long time, they will accumulate a lot of water in the area of ​​the car. When the water spreads to the car body, it will cause the body to rust. Therefore, it is necessary to carry out regular inspections on the parts where the moisture in the vehicle is easily hidden. In particular, the parts where the cover of the vehicle is covered are the inspection targets. 2. If it is found that signs of rust begin to appear in the car body, but the situation is not too serious, then the owner can use a very fine water sandpaper to gently rub the rust. However, it is worth noting that, when rubbing, it must be done along the straight line in the same direction, gently clean the outer primer and then apply a new primer on it. If new scratches are found while rubbing, you can rub off the primer directly around it, rub the entire scratch down, then apply a new primer. 3, regularly check the body of all kinds of inconspicuous parts. The surfaces of bulk feed carriers are often bumped and scratched, and too fast during driving can cause the stone to splash and cause the paint to slide off. If these small parts are not regularly inspected, it is easy. Rust on the top of the body. The above is a method that can effectively reduce the rust on the body of a bulk feed carrier. However, if you do not find the touch up pen that was originally produced for the touch up operation during the touch up process, then for small scratches, It can still be repaired by rubbing. If the scratch is relatively large, it is better to go to a large repair shop to do a paint job.
Heat exchanger parts are an important part of the heat exchanger. During the use of the heat exchanger, the parts may wear out and the entire heat exchanger cannot be used. At this time, we need to replace the damaged parts. When components in a heat exchanger wear out, it can result in product loss in the equipment. Minimize costly downtime by getting replacement parts from Jiema. Worn parts can cause inconsistencies in the production process, slowing down production or stopping production altogether. With Jiema's wide range of heat exchanger replacement parts, you can keep your productivity at peak efficiency and scale up your output reliably. No matter what make or model you have in your facility, we've got the parts you need. Jiema has a large inventory of OEM replacement parts, including most of the well-known brands.
Heat exchanger components include plate heat exchangers, air heat exchangers, and shell-and-tube heat exchangers. Frequently replaced parts include plates and rubber pads of plate heat exchangers, finned tubes of air heat exchangers, condensing coils, seamless steel pipes, U-shaped tubes, tube sheets and flanges of shell-and-tube heat exchangers, etc. In the following, we will further display each component and its characteristics and uses.
Heat Exchanger Parts,Exchanger Pipe,Seamless Tube,Heat Exchanger Tube Guangdong Jiema Energy Saving Technology Co.,Ltd , https://www.heatexchangerjiema.com