High Speed Door For Air Shower Use High Speed Door For Air Shower Use,Air Shower High Speed Door, Cargo Shower High Speed Door, Air Shower Room High Speed Door, Cargo Shower Room High Speed Door SHENZHEN HONGFA AUTOMATIC DOOR CO., LTD , http://www.hongfafrs.com
First, why does the colorful film film edge?
1, the grassroots processing is not clean:
Wall base treatment is not clean; or because the surface is rough, too dry or wet, so that the paint and the grass-roots layer is not firmly bonded, after the film shrinkage, the edge of the film is picked up and curl.
2, glue adhesion is too low:
Adhesive adhesive strength is not enough, with the base layer bonding is not strong, especially in the female corner, the most likely due to loose adhesion and tilt. Yang Yang Department of Yang used in the film edge of the film is less than 2cm, and the adhesive strength is not large enough, it is also easy to Alice.
3, hands are stained with dust when pasting colorful film:
When sticking the colorful film, the worker or the master's hands are covered with dust. When the finger touches the edge of the colorful film, the dust adheres to the colorful film, which results in the decrease of the adhesive force of the colorful film and makes it easy to curl up.
4, decoration company shoddy:
The decoration company uses a thin fancy dress film. Its paper base is relatively thin, and it usually takes 2 to 3 years. For restaurants and hotels, 2 to 3 years must be renovated. . In addition, the price of thin colored film has an incomparable advantage. Some decoration companies rush in order and take a thin film of color film, especially some colorful film made of large books, when they are sold to customers. It is unavoidable that the colorful film will be curled.
5, color film itself problem:
Generally poor quality of the colorful film will often appear Alice side of the situation, there are some poor quality PVC film, paper-based and plastic surface water expansion rate is not the same, easily lead to the arch edge, this situation, paper-based and plastic surface Already separated, only color film can be replaced. And poor quality PVC film is not airtight, the gas generated by the putty layer itself is not able to see through, easy to produce alice and bubbling and other phenomena.
Second, how to avoid the Alice film edge?
1, grassroots clean up:
Remove dirt and dust on the surface of the wall. Must use putty to flatten the uneven surface.
2. Keep your hands clean:
Pay attention to the cleanliness of hands during pasting of the film.
3, use special glue:
When you paste, you need to use special film for plastic film. Before the construction, samples should be tested and posted.
4, choose the appropriate color film paste tool:
In order to make the tightness of the colorful film joints, different tools can be used for different types of colorful film to flatten and compact, squeeze out the excess adhesive glue, and wipe off the residual solution with a wet towel. Pressure along the edge of the sewing force evenly, should not be too large, to prevent the adhesive squeeze dry and form non-adhesive. The rubber towel should not be too large to prevent the adhesive from being squeezed to form a non-adhesive bond. Wipe the plastic towel should not be too wet, to avoid the water from the edge of the paper to see people wash glue and reduce the paste strength.
5, use thick PVC color film:
Guangzhou Yuan Yi thick pvc color film, thick pvc color film has the following advantages: good environmental protection, good air permeability, strong bonding, long service life.
Third, how to deal with color film Alice?
If it is found that the color film film has a curled edge, it is necessary to first turn up the curled edge, then apply a special glue for the color film, blow the glue into 80% dry with a hot air blower, and finally use a scraper to scrape from the top to the bottom. No trace can be.
Home decoration film Alice, how to deal with
Home decorating film can play a very decorative role, so many decoration owners are inclined to use the film to create a home environment they like, this can also add a lot to the room, but the film is A series of problems often appear in the process of use, such as the phenomenon of colorful edges and edges of the colorful film. How to deal with color film Alice? The following Xiaobian of Guangzhou Yuanyi Company will answer for you one by one. Let's take a look.